As reported on GitHub. When logging to a remote host, after a few
SIGHUP's we get the following log message:
Only 16 IP addresses per socket supported.
When closing all currently open sockets, the socket count must be reset
to allow for opening new ones, otherwise we'll run out of "counts".
Yes, this should be refactored to use the FreeBSD model implementation.
Problem introduced in v2.4.0, commit 075815e.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
This patch refactors the way the primary and secondary syslogd is
started by the test framework. The generalizations not only make the
code more readable, it hopefully also makes it easier to add new tests
in the future.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
Since we currently cannot test kernel logging, and we don't want to risk
any log messages from the kernel to suddenly pop up and disturb tests,
this patch explicitly disables it.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
Refactor test.rc, start.sh, and stop.sh into lib.sh that each test
sources and uses independently of each other.
More simplfication and cleanup needed.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
The release suite fails with no permissions to dump loopback, so let's
run tests in an unshare, one per test, with and start as many syslogd as
needed for each test -- also easier to debug since all are then fully
stand-alone.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
It's a lot easier to debug the remote test with Wireshark if we log to
the default service port on the remote host.
Signed-off-by: Joachim Nilsson <troglobit@gmail.com>
Even on my laptop it sometimes takes a bit too long for tshark to start
up and syslogd to actually FWD the $MSG to remote.
Signed-off-by: Joachim Nilsson <troglobit@gmail.com>
